TI中文支持网问题现象：终端整机上电后，srio msg消息发送（板内dsp间消息发送）概率性失败（整机上下电重启后，50%几率出错）
问题分析：查看srio寄存器，发现如下：
1)Error Management Register中的寄存器Error Detect register(ERR_DET) = 0x01000000
寄存器手册上，位24对应的描述：
24 Packet Response Time-out :A required response has not been received within the specified timeout
interval (IO/MSG/GSM logical) (end point device only)
Write 0 to clear
Write 1 for software debug purposes only
2)CSR/CAR Registers中的寄存器port error and status CSR n(SPn_ERR_STAT) = 0x03020202
寄存器手册上，各位值对应的描述：
25 Output Failed-encountered： Output port has encountered a failed condition, meaning that the failed port
error threshold has been reached in the Port n Error Rate Threshold register.
Once set remains set until written with a logic 1 to clear.
24 Output Degraded-encountered：Output port has encountered a degraded condition, meaning that the degraded port
error threshold has been reached in the Port n Error Rate Threshold register. Once set
remains set until written with a logic 1 to clear.
17 Output Error-encountered： Output port has encountered (and possibly recovered from) a transmission error. This
bit is set when bit 16 is set. Once set, remains set until written with a logic 1 to clear.
9 Input Error-encountered： Input port has encountered (and possibly recovered from) a transmission error. This bit
is set when bit 8 is set. Once set, remains set until written with a logic 1 to clear.
1 Port OK： The input and output ports are initialized and the port is exchanging error-free control
symbols with the attached device (read-only).
问题1：上述现象发生原因？
问题2：上述问题如何避免，出问题后如何恢复？
Allen35065：
如果是DSP间传输出问题，信号质量的问题可能性比较大，依次做内部环回，降速等手段进行排查，TX侧可以试着提高TX Swing的值。
