生成的out文件，无法下载dsp中

工程师你好，我用6678的评估版，自己编写的程序，编译通过，已经生成out文件了，链接不通过，

C66xx_0: Trouble Writing Memory Block at 0xa89800 on Page 0 of Length 0x2910: (Error -1190 @ 0xA23300) Unable to access device memory. Verify that the memory address is in valid memory. If error persists, confirm configuration, power-cycle board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.1.232.0)

C66xx_0: GEL: File: D:\workspace_v5_5\MyMessageQ\Debug\MyMessageQ.out: Load failed.

C66xx_0: Error: (Error -1190 @ 0x0) Unable to access device memory. Verify that the memory address is in valid memory. If error persists, confirm configuration, power-cycle board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.1.232.0)

Shine：

0xa89800这块地址在memory map里是Reserved，请查看一下cmd文件里是否有数据/代码分配到这块地址。
Table 2-2 Memory Map Summary
www.ti.com/…/tms320c6678.pdf

haotian chang：

回复 Shine:

你好，我的程序是基于bios的，是利用cfg文件生成cmd文件，我查看生成的cmd文件和vlfft例程生成的cmd文件的memory分配完全一致，而且我的cfg文件也是参考vlfft例程的

haotian chang：

回复 haotian chang:

你好我查看生成的map文件与例程生成的map文件，进行修改平台配置和cfg文件，现在已经可以下载进去了