TI中文支持网求助：DM6446的板子与XDS560仿真器连接，ARM核可以连接上，DSP核连接不上！！
希望坛子里的大神们能够指点一二.
错误提示如下：
Error connecting to the target:
Error 0x80000244/-1137
Fatal Error during: Register, Initialization, OCS,
It appears that the target is being held in reset. This may be
due to Wait-In-Reset (WIR) configuration set by the EMU0=0
and EMU1=1 pin settings. If this is the case, DISCONNECT
all CONNECTED devices including icepick and then select
RETRY to clear the WIR configuration.
If this is a multi-core system, the master CPU may not be
releasing the DSP/MCU from reset. Please check your
configuration in CC_setup and/or your GEL file to ensure that
nothing is blocking the DSP/MCU from being released from reset
Sequence ID: 0
Error Code: -1137
Error Class: 0x80000244
Board Name: DM6446 XDS560 Emulator
Cpu Name: C6400PLUS_0
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
kooking：
根据提示有两个可能：
1.板卡有相应的拨码开关需要设置
2.没有使用正确的GEL文件
JOE1：
回复 kooking:
首先，感谢你的耐心解答。
不过我觉得：
1.通过使用DaVinciEVM_arm.gel这个gel文件可以将JTAG仿真器连接正常，ARM核连接能够正常连接。
通过这个连接的建立，我觉得JTAG接口应该是配置正常的。
2.gel文件使用的是正确的，是DaVinciEVM_dsp.gel这个文件。
PS:板子是合众达的开发板，仿真器是SEED-XDS560PLUS
