TI中文支持网[Start]
Execute the command:
%ccs_base%/common/uscif/dbgjtag.exe -f %boarddatafile% -rv -F inform,logfile=yes -S pathlength -S integrity
[Result]
—–[Print the board config pathname(s)]————————————
C:\Users\lenovo\AppData\Local\.TI\2685331358\
0\0\BrdDat\testBoard.dat
—–[Print the reset-command software log-file]—————————–
This utility has selected a 560/2xx-class product.
This utility will load the program 'seed560v2u.out'.
Loaded FPGA Image: E:\ti\ccsv5\ccs_base\common\uscif\dtc_top.jbc
The library build date was 'Aug 19 2013'.
The library build time was '22:41:20'.
The library package version is '5.1.229.0'.
The library component version is '35.34.40.0'.
The controller does not use a programmable FPGA.
An error occurred while hard opening the controller.
—–[An error has occurred and this utility has aborted]——————–
This error is generated by TI's USCIF driver or utilities.
The value is '-183' (0xffffff49).
The title is 'SC_ERR_CTL_CBL_BREAK_FAR'.
The explanation is:
The controller has detected a cable break far-from itself.
The user must connect the cable/pod to the target.
[End]
join join：
C55xx: Trouble Halting Target CPU: (Error -1138 @ 0x400) Device refused to allow debug mode. Power-cycle the board. If error persists, confirm configuration and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.1.232.0)
join join：
回复 join join:
Error connecting to the target:(Error -1143 @ 0x5F)Device core was hung. The debugger has forced the device to a ready state and recovered debug control, but your application's state is now corrupt. You should have limited access to memory and registers, but you may need to reset the device to debug further.(Emulation package 5.1.232.0)
join join：
回复 join join:
Can't find a source file at "/tmp/TI_MKLIB4kQNZn/SRC/boot.asm" Locate the file or edit the source lookup path to include its location
noaming：
首先The controller has detected a cable break far-from itself.
检查一下硬件连接是否正确，XDS560使用的也是14PIN的JTAG吗
另外注意使用仿真器测试工具先检测一下仿真器驱动是否没问题。
join join：
回复 noaming:
驱动没问题啊，硬件也没问题。标准设计。100v2连接没问题，就560v2plus连接不上
noaming：
回复 join join:
那一块板子？先降低TCLK的频率到最低试试
CCS的版本，以及你电脑系统的版本是多少？
join join：
回复 noaming:
C5505，WIN7 64BIT CCS5.5
Zhan Xiang：
回复 join join:
你的TRST管脚有用外接电阻接地吗？
join join：
回复 Zhan Xiang:
不是那个管脚不是和DSP直接连在一起么
join join：
回复 Zhan Xiang:
你使用外接电阻接地不是使DSP一直处于仿真复位的模式么。
我是不理解接地这个说法？
