TI中文支持网使用CC3200 LAUNCHPAD的仿真器仿真自己做的板子的时候出现如下问题：
请问如何解决。
注：
1）完全按照guaid的文档来进行操作。
2）各路电压也完全正常，用示波器对比launchpad测试。
3）SOP的上电时序，复位时序也正常，晶振都正常工作。
4）32K使用外部晶振。
另外 ：32K的晶振是否一定要提供？
谢谢
Error connecting to the target:
Timed out while waiting for target powerup/polling a hardware resource.
Susan Yang：
1. Check if you have exceeded your FLASH/RAM code limits.
2. If they are fine, try Flashing using the TI programmer.
3. If programming is fine, then the setup (connections to target) is fine.
4. Check the debugger options (select the right debugger) in CCS.
roc zhou：
回复 Susan Yang:
1. Check if you have exceeded your FLASH/RAM code limits.
just debug example in SDK
2. If they are fine, try Flashing using the TI programmer.
I use UNIFLASH to down load and debug it with ccs6.0.1
3. If programming is fine, then the setup (connections to target) is fine.
It's all fine,some times it's work good ,but almost time it's begin the error.
4. Check the debugger options (select the right debugger) in CCS.
also it's right. I use SWD.and config ccs to SWD.
