TI中文支持网我使用的是TMDXEVM6678和CCS 5.2.1，在连接的时候，按照正常的亮灯顺序，应该是绿灯亮，然后黄灯和红灯亮。
但是我现在上电，绿灯亮后，只有红灯亮，黄灯没有反应。而且，我现在也没有处于安全模式。
测试连接时，输出如下：
[Start]
Execute the command:
%ccs_base%/common/uscif/dbgjtag.exe -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity
[Result]
—–[Print the board config pathname(s)]————————————
C:\Users\ADMINI~1\AppData\Local\.TI\213602635\
0\0\BrdDat\testBoard.dat
—–[Print the reset-command software log-file]—————————–
This utility has selected a 560/2xx-class product.
This utility will load the program 'bh560v2u.out'.
The library build date was 'May 30 2012'.
The library build time was '23:17:26'.
The library package version is '5.0.747.0'.
The library component version is '35.34.40.0'.
The controller does not use a programmable FPGA.
An error occurred while hard opening the controller.
—–[An error has occurred and this utility has aborted]——————–
This error is generated by TI's USCIF driver or utilities.
The value is '-100' (0xffffff9c).
The title is 'SC_ERR_BAD_GENERIC'.
The explanation is:
The controller or software detected an error with an unknown cause.
This error number is used when detailed information is not available.
[End]
请问，现在应该如何才能连上板子呢？？
谢谢！
Andy Yin1：
把blackhawk子卡摘下来，试试EVM主板自带的XDS100 emulator。
