TI中文支持网SPL: Please implement spl_start_uboot() for your board
SPL: Direct Linux boot not active!
reading u-boot.img
U-Boot SPL 2013.10 (Aug 14 2017 – 02:17:20)
SPL: Please implement spl_start_uboot() for your board
SPL: Direct Linux boot not active!
reading u-boot.img
spl: error reading image u-boot.img, err – -1
### ERROR ### Please RESET the board ###
chuangquan nong：
SD卡启动打印信息如下：
U-Boot SPL 2013.10 (Aug 14 2017 – 02:17:20)SPL: Please implement spl_start_uboot() for your boardSPL: Direct Linux boot not active!reading u-boot.imgreading u-boot.imgU-Boot 2013.10 (Aug 14 2017 – 02:17:20)I2C: readyDRAM: 1 GiBlcd_bl_initMMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1Using default environmentInit vbus0: 500mA@5V, OFFInit vbus1: 500mA@5V, ONNot found the LCD header ICNet: <ethaddr> not set. Validating first E-fuse MACCould not get PHY for cpsw: addr 0cpswHit any key to stop autoboot: 0 Card did not respond to voltage select!mmc0(part 0) is current deviceScanning mmc 0…Card did not respond to voltage select!** Bad device mmc 0 **Card did not respond to voltage select!mmc0(part 0) is current deviceCard did not respond to voltage select!** Bad device mmc 0 **## Error: "bootcmd_qspi" not defined(Re)start USB…USB0: Register 2000440 NbrPorts 2Starting the controllerUSB XHCI 1.00scanning bus 0 for devices… 1 USB Device(s) found scanning usb for storage devices… 0 Storage Device(s) foundUSB device 0: unknown deviceU-Boot#
Shine：
先检查一下SD卡制作是否正确？
processors.wiki.ti.com/…/Linux_Core_U-Boot_User's_Guide
yongqing wang：
成功启动过吗
