现在的问题代码是:
Error connecting to the target:
Error 0x80002240/-233
Fatal Error during: Initialization, OCS, Control,
This error was generated by TI's USCIF driver.
SC_ERR_PATH_BROKEN <-233>
The JTAG IR and DR scan-paths cannot circulate bits, they may be broken.
An attempt to scan the JTAG scan-path has failed.
The target's JTAG scan-path appears to be broken
with a stuck-at-ones or stuck-at-zero fault.
Board Name: DM6437 XDS560 Emulator
Cpu Name: ICEPICK_C_0
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
请教一下各位大神,这是仿真器的问题还是硬件电路的问题呢?谢谢!
Seven Han:
你好,DM6437属于 TMS320C64x+™ DSP,可以到dsp论坛提问,更有效。
现在的问题代码是:
Error connecting to the target:
Error 0x80002240/-233
Fatal Error during: Initialization, OCS, Control,
This error was generated by TI's USCIF driver.
SC_ERR_PATH_BROKEN <-233>
The JTAG IR and DR scan-paths cannot circulate bits, they may be broken.
An attempt to scan the JTAG scan-path has failed.
The target's JTAG scan-path appears to be broken
with a stuck-at-ones or stuck-at-zero fault.
Board Name: DM6437 XDS560 Emulator
Cpu Name: ICEPICK_C_0
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.
请教一下各位大神,这是仿真器的问题还是硬件电路的问题呢?谢谢!
Linda:
回复 Seven Han:
您好!
请问是什么C2000芯片?用的是什么仿真器?该仿真器在其他板上是否能正常工作?