TI中文支持网我用 CC1310 LaunchPad,
CCS v8.1.0.00011
原本 load program 都 OK,
今天 load program fail, 出現下列訊息, 請問要如何修復 ? 謝謝
Cortex_M3_0: Trouble Reading Register REG_ENDIAN: (Error -261 @ 0x0) Invalid response was received from the XDS110. (Emulation package 8.0.27.9)Cortex_M3_0: Trouble Halting Target CPU: (Error -122 @ 0x0) A bad parameter value was detected within a function. It is likely a problem with `SC_ARGS' in SMG_call(). (Emulation package 8.0.27.9)Cortex_M3_0: Error: (Error -122 @ 0x0) A bad parameter value was detected within a function. It is likely a problem with `SC_ARGS' in SMG_call(). (Emulation package 8.0.27.9)Cortex_M3_0: Unable to determine target status after 20 attempts
Cortex_M3_0: Failed to remove the debug state from the target before disconnecting. There may still be breakpoint op-codes embedded in program memory. It is recommended that you reset the emulator before you connect and reload your program before you continue debugging
Cortex_M3_0: File Loader: Memory write failed: Could not read 0x20000B08: target is not connected
Cortex_M3_0: GEL: File: G:\STT\TI\CCS-workspace\sensor_cc1310lp\sensor_cc1310lp\sensor_cc1310lp.out: Load failed.
YiKai Chen：
試試看用flash programmer 2去做mass erase.
Viki Shi：
界面右上角force mass erase试一下
Joy Lin：
回复 YiKai Chen:
試過了, 還是不行.
Joy Lin：
回复 Viki Shi:
試過了, 還是不行.
YiKai Chen：
回复 Joy Lin:
試試重開電腦換條USB cable再測試看看
Joy Lin：
回复 YiKai Chen:
試過了, 還是不行.
YiKai Chen：
回复 Joy Lin:
我重新安裝 CCS 就可以了.又說試過了, 還是不行.現在還有問題嗎？
Joy Lin：
回复 YiKai Chen:
不好意思, 第一次 post 文, 我先回報我解決的方式, 之後才回復您的貼文, 結果顯示的文章先後次序造成您的誤會.我重新安裝CCS 就可以了. 只是不曉得是不是正確的解法. 想看看 TI 是不是有正確的解法 ? 謝謝.
YiKai Chen：
回复 Joy Lin:
可以用就行了，通常出現奇怪問題的時候，TI也都會建議用戶重裝試試
