Part Number:DRV8353
DRV8353 drive waveform testing:
48V, PWM 20KHZ, dual mosfet, sink 600ma,source 400ma , Dead-time200ns
The schematic diagram is as follows:
1-channel (yellow) GHC-SHC, upper bridge VGS voltage
2-channel (green) SHC, phase voltage
3-channel (blue) GLC, lower bridge VGS voltage
The lower bridge VGS has oscillations with a significant amplitude, and the upper bridge also experiences voltage rise. Is it reasonable or does it have hidden dangers. I tried to suppress the amplitude of the oscillation:
1)100K resistors are connected in parallel between VGS, without significant changes
2)Reduce the driving current, sink 300ma source 300ma ,The falling edge slows down, but the shaking still exists, and the shaking amplitude should be lower
3)Increase the driving current, sink 800ma source 550ma ,The edge shakes more, but the shaking still increases
4)The driving current remains unchanged (sink 600mA source 400mA), and without 100pF between GS and 100K pull-down resistor, the oscillation increases slightly
5)Adjust the driving current (sink 600mA source 300mA) and add 100pF. Without 100K pull-down, the oscillation increases slightly ,Is this OK?
Links:
感谢您对TI产品的关注!为更加有效地解决您的问题,我们建议您将问题发布在E2E英文技术论坛上( https://e2e.ti.com/p/addpost ).将由资深的英文论坛工程师为您提供帮助。
TRANSLATE with x
English
Arabic
Hebrew
PolishBulgarian
Hindi
PortugueseCatalan
Hmong Daw
RomanianChinese Simplified
Hungarian
RussianChinese Traditional
Indonesian
SlovakCzech
Italian
SlovenianDanish
Japanese
SpanishDutch
Klingon
SwedishEnglish
Korean
ThaiEstonian
Latvian
TurkishFinnish
Lithuanian
UkrainianFrench
Malay
UrduGerman
Maltese
VietnameseGreek
Norwegian
WelshHaitian Creole
PersianTRANSLATE with
COPY THE URL BELOW
BackEMBED THE SNIPPET BELOW IN YOUR SITE
Enable collaborative features and customize widget: Bing Webmaster Portal
Back