TLV320AIC3104: TLV320AIC3104 can't record and aplay

Hello

 I am using linux4.19 kernel, chip is tlv320aic3104, and then the menuconfig configuration <*> Texas Instruments TLV320AIC3x CODECs, my device tree configuration when the audio input, I can control the output from bypass to RIHGHT_LOP/M. What I want to achieve is a configuration with red differential inputs, and green differential outputs. But when I execute arecord -D hw:0,0 -f S16_LE -d 10 -c 2 -r 16 -t wav 001.wav, the audio doesn't output from the i2s to the cpu, play the audio aplay sin.wav sound comes out from the cpu, But I'm not sure it made it into the 3104 chip. When using linux4.1 before, configuring audio was able to achieve what I needed, I couldn't achieve it using the same configuration.

I hope to achieve my needs through alsa command and ask for your help.

Best Regards

Note 1: I noticed a change in the numid number between the old version of the alsa command and the new version. For example：

numid=42,iface=MIXER,name='Right Line1L Mux'、numid=43,iface=MIXER,name='RightLine1RMux'

Note 2: My command to configure the recording is

amixer cset numid=32,iface=MIXER,name='PGA Capture Switch' on,of

amixer cset numid=31,iface=MIXER,name='PGA Capture Volume' 31,31

amixer cset numid=23,iface=MIXER,name='AGC Switch' off,off

amixer cset numid=40,iface=MIXER,name='Left Line1L Mux' 2

amixer cset numid=44,iface=MIXER,name='Left PGA Mixer Line1L Switch' on

amixer cset numid=37,iface=MIXER,name='Left HPCOM Mux'

My device tree:

sound {
		compatible = "simple-audio-card";
		simple-audio-card,name = "tlv320aic3104";
		simple-audio-card,format = "i2s";
		simple-audio-card,mclk-fs = <256>;
		simple-audio-card,bitclock-master = <&dailink0_master>;
		simple-audio-card,frame-master = <&dailink0_master>;
		simple-audio-card,widgets =
			"Microphone", "Microphone Jack",
			"Headphone", "Headphone Jack",
			"Speaker", "External Speaker",
			"Line", "Line Out",
			"Line", "Line In";
		,routing =
			"MIC_IN", "Microphone Jack",
			"Headphone Jack", "HP_OUT",
			"LINE1L", "Line In",
			"LINE1R", "Line In",
			"Headphone Jack", "RLOUT",
			"Headphone Jack", "LLOUT";

		dailink0_master:simple-audio-card,cpu {
			sound-dai = <&sai1 0>;
		};

		simple-audio-card,codec {
			sound-dai = <&codec 0>;
			/* clocks = <&clks IMX6UL_CLK_SAI1>; */
		};
	};

&clks {
	assigned-clocks = <&clks IMX6UL_CLK_PLL4_AUDIO_DIV>;
	/* assigned-clock-rates = <1179648000>; */
	assigned-clock-rates = <786432000>;
	/* assigned-clock-rates = <705600000>; */
};

&i2c1 {
	clock-frequency = <100000>;
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_i2c1>;
	status = "okay";
	
	codec: tlv320aic3104@18 {
		#sound-dai-cells = <0>;
		compatible = "ti,tlv320aic3104";
		reg = <0x18>;
		gpio-reset = <&gpio5 2 GPIO_ACTIVE_LOW>;
		ai3x-micbias-vg = <0>;
		/* Regulators */
		DRVDD-supply = <&reg_3p3v>;
		AVDD-supply = <&reg_3p3v>;
		IOVDD-supply = <&reg_3p3v>;
		DVDD-supply = <&reg_1p8v>;
		status = "okay";
	};

	eeprom@50 {
		compatible = "atmel,24c02";
		reg = <0x50>;
	};
};

&sai1 {
	#sound-dai-cells = <0>;
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_sai1>;
	assigned-clocks = <&clks IMX6UL_CLK_SAI1_SEL>,<&clks IMX6UL_CLK_SAI1>;
	assigned-clock-parents = <&clks IMX6UL_CLK_PLL4_AUDIO_DIV>;
	/* assigned-clock-rates = <2>, <12288000>; */
	assigned-clock-rates = <2>, <24576000>;
	/* assigned-clock-rates = <2>, <28224000>; */
	status = "okay";
};

Amy Luo：

您好，

我之前建议您将问题发布在E2E英文技术论坛上，您是不能发布吗？因为我看您的邮箱是公司域邮箱可以在英文论坛发帖的。

英文论坛在下面链接发帖：https://e2e.ti.com/support/audio-group/audio/f/audio-forum

,

ka ka：

好的，谢谢。我之前没有注意到发送的是中文论坛。