TI中文支持网Part Number:TDA4AP-Q1
Hello, I would like to ask how to determine the DIO channel ids of WKUP_GPIO0_42 and WKUP_GPIO0_52 when using EB to configure DIO for J784S. Is there a table like Pin mapping for SOCS for reference like J721E
Shine：
目前还没有J784S的pin mapping。
,
? ?：
Thank you very much for your answer. When I use EB to configure DIO in TDA4 J748S4, how is the GIO channel ID of the WKUP GPIO0 B23 group defined? If I want to configure WKUP GPIO0 52, what should I set his DIO channel ID to?
,
? ?：
J784S4
,
Shine：
已询问e2e论坛工程师，请关注下面帖子的回复。由于国外圣诞节和新年假期，回复可能会延迟到 1 月 2 日，感谢您的耐心等待。https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1307077/tda4ap-q1-j784s-dio-pin-mapping
,
Shine：
抱歉回复晚了，请看下面工程师的回复。请问"how to determine the channel ids"是什么意思？能否详细说明一下。
GPIO管脚如下。
我们在mcal里有例程，也可以看一下。
,
? ?：
Thank you for your reply:, according to the above manual WKUP_GPIOu[84:143](u=0,1)，But the code in SDK is shown in the red box as follows: "reservedPinStart=32, not 84. Is the SDK wrong? Do I need to change it into" reservedPinStart=84, numPins =59 "?
,
Shine：
这可能是个bug，请问使用的是哪个版本的SDK?Exactly.I think this should be a bug to be reported, I had raised similar bug for J721S2 i can add j784s4 into it .May i know which SDK version is this ?
