TIDA-01022: TIDA-01022+TSW14J57EVM问题

您好，我使用 TIDA-01022 和两个TSW14J57来验证ADC12DJ3200同步。HSDC PRO使用触发模式，两个ADC之间的相位有时会跳跃一个LMFC周期。这是正常现象吗？

另外，我参考“ TSW14J57revE固件设计文档“并发现TSW14J57不支持基于 sysref 的触发模式。你有可以支持它的固件吗？

请帮忙在英文论坛上问一下，以下为翻译：

Hello, I used TIDA-01022 and two TSW14J57 to verify ADC12DJ3200 synchronization. HSDC PRO uses trigger mode, and the phase between the two ADCs sometimes jumps by one LMFC cycle. Is this a normal phenomenon?

In addition, I refer to the “ TSW14J57revE Firmware Design Document”and found that TSW14J57 does not support sysref based trigger mode. Do you have any firmware that can support it?

Cherry Zhou：

Hi,

您的问题我们已经升级到英文论坛寻求帮助，链接给您贴在下面：

https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1290831/tida-01022-tida-01022-tsw14j57evm-issue

Thanks

,

li jack：

多谢多谢