LM25119: Interleave mode can run under TINA-TI application

I make a LM25119 DCDC generator under interleaved mode in TINA-TI app. but I find app pop up a error message which show as below.  I am sure this circuit can work and the component I put is fine. I try to change mode from interleaved mode to single mode. then system can work.

I suspect this model can't support interleaved mode. anyone can confirm it for me?

Johnsin Tao：

HI  

   有可能是的，不过仍建议你在美国E2E上再确认一下：https://e2e.ti.com/    美国E2E是有模型工程师的，可以帮到你（可能有适合的模型，或者能修改），而我们仅仅只能提供官网上的模型。