=> tftp 0x80000000 uEnv.txt
**************_cpsw_init**************
link up on port 0, speed 100, full duplex
Using ethernet@4a100000device
TFTP from server 192.168.1.200; our IP address is 192.168.1.201 Filename 'uEnv.txt'.
Load address: 0x80000000
Loading: # 55.7 KiB/s done
Bytes transferred = 285 (11d hex)
=> tftp 0x80000000 MLO
**************_cpsw_init**************
link up on port 0, speed 100, full duplex Using ethernet@4a100000 device
TFTP from server 192.168.1.200; our IP address is 192.168.1.201 Filename 'MLO'.
Load address: 0x80000000
Loading: #
Abort
=> tftp 0x80000000 am335x-boneblack.dtb
**************_cpsw_init************** link up on port 0, speed 100, full duplex
Using ethernet@4a100000 device
TFTP from server 192.168.1.200; our IP address is 192.168.1.201 Filename 'am335x-boneblack.dtb'.
Load address: 0x80000000 Loading: #T T T T
Abort
=> tftp 0x80000000 am335x-boneblack.dtb
**************_cpsw_init************** link up on port 0, speed 100, full duplex
Using ethernet@4a100000 device
TFTP from server 192.168.1.200; our IP address is 192.168.1.201 Filename 'am335x-boneblack.dtb'.
Load address: 0x80000000
Loading: T #T T T #T T T T T #T T T
Shine:
请问用的是最新的processor SDK么?
user6350786:
回复 Shine:
用的是ti-processor-sdk-linux-am335x-evm-06.01.00.08
Shine:
回复 user6350786:
请检查一下tftp server的设置,参考下面的帖子。
sudo tcpdump -vvv -i any -n host 172.20.1.223
e2e.ti.com/…/273679
user6350786:
回复 Shine:
没看到有设置TFTP server的设置啊
Shine:
回复 user6350786:
请问cache有没有打开?检查一下PHY的速度设置和初始化时cpu主频的设置。
user6350786:
回复 Shine:
用dcache on命令打开了,但没什么效果,PHY为100M, mpu594 MHz
Shine:
回复 user6350786:
请问是自己的板子还是TI EVM板?Linux端的TFTP server是怎么配置的?看上去像是am335x-boneblack.dtb传输失败?这个文件放在server上的正确的地方了么?