TI中文支持网
TI专业的中文技术问题搜集分享网站

sn74avc8t245问题

Hi,

I am using sn74avc8t245 as voltage shifter from 0~3.3 V to 0~2.4 V, I have three questions regarding this part:

1. How should I connect the pins (i.e VCCA, Two VCCB, DIR, OE)

2. What does continuous output current mean (under absolute maximum ratings on page 3)? What is the difference between continuous output current and IOH/IOL?

3. Is this part able to drive a 50 Ohm resistor? If not, do you know any part can drive 50 Ohms with a voltage level of 0~2.4?

Many thanks in advance!

Miao

Carter Liu:

Hi,

1.VCCA and VCCB are the two supply voltage for voltage level switch.DIR controls the direction between VCCA and VCCB,OE is the enable pin.

2.Continuous output current is relative to the pulse current,IOH High-level output current,IOL Low-level output current;

3.most of the time it is not used to drive a load,but used for BUS TRANSCEIVER.

Carter

赞(0)
未经允许不得转载:TI中文支持网 » sn74avc8t245问题
分享到: 更多 (0)